Power steering return line, B207 LHD
Power steering return line, B207 LHD |
Important | ||
Scrupulous cleanliness must always be observed during all work with hydraulic components. |
||
To remove |
1. |
Remove the driver-side wheel.
|
2. |
Open the reservoir cap.
|
3. |
Raise the car.
|
4. |
Disconnect the return line from the steering gear and allow the fluid to drain into a suitable receptacle.
|
5. |
Lower the car to the floor.
|
6. |
Remove the line from the reservoir.
|
7. |
Raise the car and pull our the line from under the car.
|
To fit |
1. |
Fit the line in place.
|
2. |
Attach the line to the steering gear. Make sure the O-ring is correctly seated.
Tightening torque 28 Nm (21 lbf ft) |
3. |
Lower the car to the floor.
|
4. |
Attach the line to the power steering fluid reservoir.
|
5. |
Fill with fluid and
bleed the power steering system
.
|
6. |
Fit the
wheel
.
|