SAAB WIS ONLINE

Bumper shell, front, 9-3X

Bumper shell, front, 9-3X

To remove


1. Remove the upper radiator member's clips (A) and bolts (B).


2. Raise the car.

3. Remove the bumper bolts in the (C) wing liner.


4. Press locking tab (A) on the clips, unhook the catch (B) from the bumper shell and pull out the front section of the wing moulding (C).


5. Remove the spoiler shield's bolts (A). Unplug the connector (B) and detach the connector (C).

Cars with headlamp washing: Detach the washer hose's quick release coupling from the reservoir and seal the connection if necessary.


6. Pull bumper shell's corner (A) from the holder's mounting. At the same time, pull out the front section of the wing moulding (B).


7. Lift off the bumper shell.


To fit


1. Check that the cellular block is in place in the shell.

2. Fit the bumper. Press the casing backwards, and firmly press the casing's clips into the holder (A). At the same time, pull out the front section of the wing moulding (B).


3. Press in the clips on the front section of the wing moulding into the grooves.

4. Fit the bumper bolts (C) for the wing liner.


5. Fit the clips (A) and bolts (B) on the upper radiator member.


6. Attach the connector (C) and plug in the connector (B). Fit the spoiler shield's bolts (A).

Cars with headlamp washers: Fit the washer hose.


7. Lower the car and check the fit of the bumper shell.