Bumper shell, rear, 5D
Bumper shell, rear, 5D |
To remove |
1. |
Raise the car.
|
2. |
Remove the middle spoiler nuts.
|
3. |
Remove the bolts in the wheel housing.
|
4. |
Lower the car and open the tailgate.
|
5. |
Open the side hatch.
|
6. |
Cars with SPA
: Remove the connector.
|
7. |
Insert a screwdriver into the hole for access under the catch. Bend up with the screwdriver to release the catch.
|
8. |
Pull off the bumper shell from the holders.
|
9. |
Release the catches with a screwdriver. Detach the shell from the moulding.
|
10. |
Lift off the bumper shell.
|
To fit |
1. |
Cars with SPA
: Insert the wiring harness..
Lift up the bumper shell and guide the tabs under the holders. |
2. |
Position the front corner of the bumper shell between the wing liner and the holder. Make sure the shell tongue lies between the wing liner and the bumper shell holder.
|
3. |
Fit the bolts in the wing liner.
|
4. |
Cars with SPA
: Plug in the connector.
|
5. |
Close the side hatch and close the tailgate.
|
6. |
Raise the car.
|
7. |
Fit the middle spoiler nuts.
|
8. |
Lower the car and check the fit of the bumper shell.
|