Bumper shell, rear, 9-3X
Bumper shell, rear, 9-3X |
To remove |
1. |
Remove
Wing moulding, rear, 9-3X
.
|
2. |
Remove the spoiler's centre nuts (A).
|
3. |
Lower the car and open the tailgate.
|
4. |
Open the side hatch.
|
5. |
Cars with SPA:
Detach the connector (A).
|
6. |
Insert a screwdriver in the hole in order to gain access under the locking catch. Bend up to release the locking catch.
|
7. |
Pull off the bumper shell (A) from the holders.
|
8. |
Release the hooks (A) using a screwdriver. Remove the shell from the moulding.
|
9. |
Lift off the bumper shell.
|
To fit |
1. |
Cars with SPA:
Thread in the wiring harness.
|
2. |
Lift up the bumper shell and guide the tabs under the holders.
|
3. |
Position the bumper shell's front corner between the wing liner and the holder. Make sure the shell's tongue is positioned between the wing liner and the bumper shell holder.
|
4. |
Cars with SPA:
Attach the connector (A).
|
5. |
Close the side hatch and close the tailgate.
|
6. |
Raise the car.
|
7. |
Fit the spoiler's centre nuts (A).
|
8. |
Lower the car and check the fit of the bumper shell.
|
9. |
Fit
Wing moulding, rear, 9-3X
.
|