Part of rear floor
Part of rear floor |
To remove |
This method refers to the right-hand side but the left-hand side can be dealt with in a similar manner.
1. |
Remove the
Rear bumper abutment
.
|
2. |
Cut the floor as indicated by the marks.
|
3. |
Drill out the spot welds.
|
4. |
Tap out the rear floor and straighten any deformed metal.
|
To fit |
1. |
Cut the replacement panel as illustrated. The cut should be made so that the replacement panel overlaps by about 20 mm.
|
2. |
Drill holes for plug welding in the replacement panel.
|
3. |
Grind all surfaces that are to be welded.
|
4. |
Apply welding primer to all surfaces that are to be plug or spot welded.
|
5. |
Put the floor in place and align it.
|
6. |
Weld the floor in place.
|
7. |
Grind the welds.
|
8. |
Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.
|
9. |
Apply primer to all bare metal surfaces.
|
10. |
Fit the rear bumper abutment
.
|
11. |
Seal joints and seams with sealant.
|
12. |
Apply PVC replacement to the underside of the floor.
|
13. |
Apply a thin film of corrosion inhibitor inside frame members and cavities after painting.
|