SAAB WIS ONLINE

Ventilation fan

Ventilation fan

To remove


1. Put the seat in its rearmost position.

2. Remove the glow box's lower screws.


3. Open the cover to the glove box.

4. Remove the upper screws and the screws inside the glove box.

5. Lift out the glove box

6. Detach the cables for the glove box lighting.

7. On cars with ACC:


Remove the cooling hose from the glove box.

8. Remove the passenger acoustic insulation .

9. Remove the lower air duct and lift out the air duct through the glove box opening.

10. Dismantle the connector for the ventilation fan control.

11. Remove the cooling hose from the clip on the fan housing.

12. Remove the fan's 7 screws.


13. Fold under the clips holding the low section of the fan housing, 3.

14. Pull the fan housing down.

15. Transfer the fan control unit if the fan is to be replaced.


To fit


1. Reposition the fan housing. The groove should grip the flange on the heating and ventilation unit.

2. Insert the clips holding the lower section of the fan housing.

3. Fit the fans 7 screws.


4. On cars with ACC

Fit the cooling hose to the heating and ventilation unit.


5. Connect the ventilation fan control's connector.

6. Fit the lower air duct.

7. Fit the passenger acoustic insulation .

8. Fit the connector for the floor lighting

9. On cars with ACC :

Fit the cooling hose in the clip on the fan housing and connect the hose to the glove box.

10. Connect the cables to the glove box lighting.

11. Insert the glove box into position.

12. Fit the screws inside the glove box and the upper screws to the glove box.


13. Close the cover to the glove box.

14. Fit the glove box lower screws.