Bootlid opening handle
| Bootlid opening handle |
| Removing |
| 1. |
Open the bootlid.
|
|
| 2. |
Remove the inner handle and bootlid trim.
|
|
| 3. |
US/CA: Loosen the wire from emergency opening handle.
|
|
| 4. |
Remove the nuts on the opening handle.
|
|
| 5. |
Unplug the connector.
|
|
| 6. |
Press in the butts and remove the opening handle.
|
|
| Fitting |
| 1. |
Insert the cable through the centre hole.
|
|
| 2. |
Guide the handle into position by means of the guide pins.
|
|
| 3. |
Push the handle so that the butts fasten.
|
|
| 4. |
Fit the nuts.
|
|
| 5. |
Plug in the connector.
|
|
| 6. |
US/CA: Insert the emergency opening wire through the hole in the trim.
|
|
| 7. |
Fit the bootlid's trim and inner handle.
|
|
| 8. |
US/CA: Fit the emergency opening handle on the wire. Fit the handle to the trim. Check the function of the emergency opening handle.
|
|
| 9. |
Close the bootlid.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
