Rear silencer
Rear silencer |
To remove |
1. |
Raise the car.
|
2. |
Cut the exhaust pipe to dimension, 100 mm. Cut it at right-angles using
83 95 667 Pipe cutter/exhaust system
.
|
3. |
Remove the rear silencer.
|
To fit |
1. |
Clean the cut to remove burrs and dirt.
|
2. |
Fit the joint clamp on the pipe.
|
3. |
Fit the rear silencer with new rubber mountings.
|
4. |
Change the rubber mountings for the front silencer as well if necessary.
|
5. |
Adjust the joint clamp so that the pipe joint is in the middle of the clamp.
|
6. |
Adjust the front and rear silencers so they balance.
|
7. |
On variants with visible tail pipe: Make sure the tail pipe is positioned centrally in the recess in the rear bumper and follows the profile of the bumper.
|
8. |
Tighten the clamp nuts.
Tightening torque 40 Nm (30 lbf ft). |
9. |
Lower the car.
|
10. |
Connect an exhaust hose and start the engine. Check that the exhaust does not leak.
|