SAAB WIS ONLINE

Oil pump sealing ring, change

Oil pump sealing ring, change

To remove


1. Remove the timing belt. See Timing belt in car, Z19DTR.

2. Remove the timing belt pulley. Use 32 025 006 Crankshaft holder in combination with 83 95 360 Holding tool, crankshaft pulley .

Note

The bolt has a left-hand thread.



3. Remove the oil pump sealing ring by prising it loose from the oil pump with a suitable tool. Make sure the sealing surfaces are not damaged.

4. Clean the sealing surfaces.


To fit


1. Moisten the sealing ring lip with a little silicone grease (white) and fit the oil pump sealing ring. Use 32 025 014 Oil pump seal fitting tool .


2. Fasten the belt pulley to 32 025 006 Crankshaft holder .

3. Fit the timing belt pulley. Use 32 025 006 Crankshaft holder in combination with 83 95 360 Holding tool, crankshaft pulley .

Tightening torque 340 Nm (251 lbf ft)

4. Remove the special tool.

5. Fit the timing belt. See Timing belt in car, Z19DTR .

6. Check the engine oil level and top up as necessary. See Recommended oil grade .