SAAB WIS ONLINE

Fuel filter, new version

Fuel filter, new version

Warning

Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

Make sure a class BE fire extinguisher is close to hand! Consider the risk of sparking, e.g. when breaking circuits, short-circuits etc.

Absolutely No Smoking!

Ensure that there is a good exchange of air. If approved ventilation for the extraction of fuel fumes is available, this should be used.

Wear protective gloves! Prolonged exposure of the hands to fuel can cause irritation to the skin.

Wear protective goggles.


To remove

Important

Be very thorough in terms of cleanliness when working in the fuel system. Malfunctions can also occur due to very small dirt particles. Prevent dirt from entering the fuel system by cleaning the hoses and plugging the pipes and lines upon removal using 93 161 370 Plug set. Store the components so that contaminants cannot enter.



1. Undo the drain screw (A) and drain the filter into a suitable receptacle.


2. Remove the filter housing cover (B).


3. Collect the fuel spill.

4. Remove the fuel filter (A). Collect any fuel spill.


5. Remove the O-ring (B).

Important

Do not use a screwdriver or other sharp tools that may damage the filter housing.



To fit


1. Fit the O-ring (B).


2. Fit the fuel filter (A).

3. Fit the filter housing cover (B).

Tightening torque 25 Nm (18 lbf ft)


4. Tighten the drain screw (A).

Tightening torque 2 Nm (1.5 lbf ft)


5. Connect an exhaust extractor hose and start the engine to check everything runs correctly.