Control module, incl. solenoid valve (724)
Control module, incl. solenoid valve (724) |
|
Important | ||
It is very important to observe maximum cleanliness when working on the differential clutch. Dirt particles can seriously damage the function and service life of the differential clutch. |
||
To remove |
1. |
Carry out
Procedures before dismantling the control module
.
|
2. |
Raise the car.
|
3. |
Remove the
exhaust system
.
|
4. |
Remove the
propeller shaft
.
|
5. |
Unhook the hooks (A) from the control module and remove the protective cover (B) from the hydraulic pump.
|
6. |
Undo the cable clips (A).
|
7. |
Remove the electrical connection (A).
|
8. |
Use a column jack as support for the differential clutch, secure with strap (A).
|
9. |
Remove the bolts (B) for the differential clutch and limited slip differential.
|
10. |
Lower the differential clutch and limited slip differential as far as the control module can be removed, take care that the drive shaft universal joints are not damaged.
|
11. |
Pull out the lock pin and remove the electrical connection (A).
|
12. |
Remove the control module and the valve (B).
|
To fit |
1. |
Fit the control module and the valve (B).
Tightening torque: 5.7 Nm (4.2 lbf ft)
|
2. |
Fit electrical connection (A).
|
3. |
Raise the differential clutch and limited slip differential.
|
4. |
Fit the bolts (B) for the differential clutch and limited slip differential.
Tightening torque: 90 Nm (66.4 lbf ft) + 90°+15° |
5. |
Remove the strap (A).
|
6. |
Fit electrical connection (A).
|
7. |
Fit cable clip (A).
|
8. |
Fit the protective cover (A) to the hydraulic pump and hook the hooks (B) into the control module.
|
9. |
Fit the
propeller shaft
.
|
10. |
Fit the
exhaust system
.
|
11. |
Lower the car to the floor.
|
12. |
Perform
Procedure after changing the control module
.
|