Rear anti-roll bar bush, 4WD
|
|
Rear anti-roll bar bush, 4WD
|
|
2.
|
Mark the position of the bushes.
|
|
3.
|
Remove the bush bolts (A) and move aside the anti-roll bar (B).
|
|
4.
|
Remove the caps and bushes from the anti-roll bar.
|
|
1.
|
Clean the anti-roll bar and lubricate the inside of the bushes with
91 63 334 Ball bearing grease
. Fit the caps and bushes on the anti-roll bar.
|
|
2.
|
Apply a thin coat of soapy water on the outside of the bush.
|
Important
|
|
Soap and water solution must not enter between bushing and anti-roll bar!
|
|
|
|
|
3.
|
Bend up the anti-roll bar (B) and fit the bush bolts (A).
Tightening torque: 30 Nm (23 lbf ft)
|
|
4.
|
Lower the car to the floor.
|
