Rear bump stop, 4WD
Rear bump stop, 4WD |
To remove |
1. |
Raise the car.
|
2. |
Relieve the weight on the lower suspension arm using an pillar jack.
|
3. |
Remove the bolt (A) securing the shock absorber to the body and slacken the bolts (B) a few turns.
|
4. |
Remove the bolt (A) holding the shock absorber to the steering swivel member and lift away the shock absorber.
|
5. |
Remove the bracket (A) with bush and bump stop (B) with protective sleeve from the shock absorber.
|
To fit |
1. |
Fit the bump stop (B) with protective sleeve and bracket (A) with bush to the shock absorber.
Tightening torque 27 Nm (20 lbf ft) |
2. |
Lift up and fit the shock absorber (A) to the steering swivel member.
Tightening torque 148 Nm +90°(109 lbf ft +90°) |
3. |
Fit the bolt (A) to the shock absorber bracket. Tighten bolts (A) and (B).
Tightening torque 53 Nm (39 lbf ft) |
4. |
Lower the car to the floor.
|