SAAB WIS ONLINE

Seat member, CV

Seat member, CV


1. Position the car in an aligning bench and cross-measure if necessary.

2. Drill out the spot welds.


3. Drill out the spot welds.


4. Grind away the seam welds to the seat member.


5. Bend up the corners slightly to easier remove the seat member.

6. Knock loose the seat member and straighten any deformed metal.

7. Grind all surfaces that are to be welded.

8. Drill holes for plug-welding in the spare part.

9. Apply welding primer to the surfaces to be spot and plug welded. Use Teroson Zink Spray.

10. Place the seat member in fitting position and secure with a few welding clamps.

11. Adjust the corner that is overlapping the seat member.


12. Spot and plug weld the seat member.


13. Seam weld the seat member.

14. Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.

15. Apply primer to all bare metal surfaces. Use Standox 1K.

16. Seal joints and seams with sealant. Use 1K-PUR.

17. Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 400.