Electromagnetic clutch, A/C compressor
|
Electromagnetic clutch, A/C compressor
|
Important
|
To avoid contaminating the system, clean the area around the parts being function and service life of the system.
|
|
2.
|
Dismantle the compressor's ground cable and the locking plate from the compressor housing.
|
3.
|
Dismantle the driver by using a 14 mm spanner and a suitable support. Pull it out of the shaft.
|
4.
|
Dismantle the circlip that holds the belt pulley and lift off the belt pulley.
Note
|
If the belt pulley jams, knock the edge using a plastic mallet so that it becomes loose.
|
|
5.
|
Dismantle the circlip holding the magnet winding and lift off the magnet winding.
Note
|
If the magnet winding jams, carefully pry using a screwdriver so that the guide pin loosens from the slot.
|
|
1.
|
Position the magnet winding in position with the guide pin in the slot on the compressor housing. Check that the cables are routed correctly. Fit the circlip.
|
2.
|
Fit the belt pulley and fit the circlip.
|
3.
|
Put the shim in the driver and position the driver on the shaft. Tighten the screw.
|
4.
|
Measure the play between the driver and the belt pulley using a feeler gauge. The play should be 0.5 ± 0.15 mm. Adjust the play if necessary but changing the shim on the compressor shaft.
Note
|
The top of the feeler gauge must be angled to measure the play.
|
|
5.
|
Fit the compressor's ground cable and locking plate on the compressor housing.
|