Bonnet lock control
Bonnet lock control |
Removing |
1. |
Undo the quick coupling on the bonnet cable, first undoing the clip from the body.
|
2. |
Split the quick coupling. Use a screwdriver.
|
3. |
Remove the cowl cover's clips.
|
4. |
Loosen the rear bonnet seal. Lift up the cowl cover a little.
|
5. |
Remove the bolts on the lower part of the panel on the driver's side.
|
6. |
Fold down the lower part of the panel.
|
7. |
Remove the lamp.
|
8. |
Remove the inner and front scuff plates.
|
9. |
Insert two screwdrivers into the control mountings and use them to press in the circlip while pulling down the control. Pull out the cable.
|
Fitting |
1. |
Thread the bonnet lock wire back through the rubber seal. Make sure the rubber seal is in position.
|
2. |
Thread the bonnet lock wire through the cowl cover's bushing.
|
3. |
Fit the cowl cover clips. Fit the rear bonnet seal.
|
4. |
Connect the quick coupling on the bonnet cable.
|
5. |
Press the clip into the body.
|
6. |
Fit the bonnet lever by positioning the lever and pressing upward.
|
7. |
Fit the inner and front scuff plates.
|
8. |
Fit the lamp. Fold back the lower part of the panel and fit the bolts.
|
9. |
Check the function of the bonnet lock.
|