Side window, front door
Side window, front door |
To remove |
1. |
Open the window approx. 5 cm.
|
2. |
Remove
Door trim, front, 4D
and fold down the water barrier.
|
3. |
Remove the outer weatherstrip. Lift up the rear edge using the removal tool.
|
4. |
Pull the strip out from the base of the door mirror.
|
5. |
Slacken the bolts to release the window.
|
6. |
Raise the rear edge of the window, angle it out slightly and lift it up.
|
To fit |
2. |
Press the window down into the rubber-covered brackets. (Image from outside)
|
3. |
Tighten the bolts.
|
4. |
Fit the outer weatherstrip. Press the weatherstrip in under the base of the door mirror then press it home along the top edge of the door.
|
5. |
Plug in the window lift connector to the door trim. Close and open the window a few times to check its operation.
|
6. |
Fit the water barrier and
Door trim, front, 4D
.
|
7. |
Cars with pinch protection
: Perform
Calibration of pinch protection
.
|
8. |
Clean the window.
|