Window lift, rear
Window lift, rear |
To remove |
1. |
Open the window approx. 10 cm and secure the window with tape.
|
2. |
Remove the door trim and water barrier.
|
3. |
Slacken/remove the bolts to release the window.
|
4. |
Remove the nuts and bolt securing the window lift.
|
5. |
Press out the window lift so that the studs come free of the mounting holes.
|
6. |
Unplug the motor.
|
7. |
Angle out the guide channel through the hole.
|
To fit |
1. |
Angle in the guide channel and insert the studs into the mounting holes.
|
2. |
Fit the nuts and bolt.
|
3. |
Plug in the connector.
|
4. |
Remove the tape.
|
5. |
Lower the window to its mountings. Press the window down into the rubber lined mountings.
|
6. |
Tighten the bolts securing the window.
|
7. |
Raise and lower the window several times to check its function.
|
8. |
Fit the water barrier and door trim.
Cars with pinch protection : Perform Calibration of pinch protection |