Motor, height adjustment, electrically operated seat (357c), CV
|
Motor, height adjustment, electrically operated seat (357c), CV
|
1.
|
Move the seat to the highest position.
Note
|
If this is not possible, the adjustment motor must be removed together with the drive.
|
|
2.
|
Disconnect the connector from the adjustment motor.
|
3.
|
Remove the adjustment motor.
Lift the adjustment motor and drive shaft out of the holder and then separate the connector. Remove the motor and pull it off the drive shaft.
|
1.
|
Fit the motor to the drive shaft. Ensure that the shaft aligns in the square hole on the motor.
|
2.
|
Fit the motor and drive shaft in the holder.
|
3.
|
Plug in the connector.
|
4.
|
Check using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard.
Delete any fault codes.
Turn off the ignition and turn it on again. Wait for at least 1 minute with the ignition on.
Check if any fault codes are displayed:
If a fault code is displayed:
Carry out fault diagnosis as instructed for each respective diagnostic trouble code.
If no fault code is displayed:
Installation is successful. Disconnect the diagnostic tool.
|