SAAB WIS ONLINE

Silencer, rear (180 hp)

Silencer, rear (180 hp)

To remove


1. Raise the car.

2. Cut the exhaust pipe as per specified measurement, 130 mm on the side to be replaced. Cut the pipe at a right angle. Use 83 95 667 Pipe cutter, exhaust system .


3. Remove the rear silencer.


To fit


1. Clean the cut to remove burrs and dirt.

2. Fit the joint clamp on the pipe. The opening should face the rear.


3. Fit the rear silencer with new rubber mountings.

4. If necessary, also replace the rubber mountings of the front silencer and the second rear silencer.

5. Adjust the sleeve clamp so that the pipe ends are in the centre of the clamp.

6. Adjust the front and rear silencers so they hang evenly.

7. If the tale pipe is visible: Check that the tail pipe is in the centre of the recess and flush with the rear bumper.

8. Tighten the nuts on the clamp.

Tightening torque 40 Nm (30 lbf ft).

9. Lower the car.

10. Connect an exhaust hose and start the engine. Check the exhaust system for leaks.