Reversing light switch, 4WD

/ 9-3 (9440) / 2012 / 3. Electrical System / Lighting and signalling systems / Exterior lighting / Adjustment/replacement / Reversing light switch, 4WD

To remove

1.	Raise the car.

2.	Unplug the connector (A).

3.	Remove the reversing light switch (B).

To fit

1.	Fit the reversing light switch (B) with a new sealing ring. Tightening torque 20 Nm (15 lbf ft)

2.	Plug in the connector (A).

3.	Lower the car.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.