SAAB WIS ONLINE

Selector unit

Selector unit

To remove


1. Remove the battery

2. Remove Battery cover, lower section .

3. Z19: Loosen the engine harness' cable tie (A).


4. Unplug the connector from the reversing light switch (A)


5. Remove the gearbox's bleed hose (B).

6. Remove the gear cables:

• Remove the gear cables from the shift arms (C).

• Press the locking sleeves backward and remove the gear cable sheaths from the bracket (D).

7. Blow clean around the selector unit

8. Remove the selector unit:

• The selector unit must be in neutral position to enable removal.

• Remove the bolts and lift up the selector unit (A).



To fit


1. Fit the sealing ring onto the selector unit (A)

• The selector unit must be in neutral position to enable fitting.


2. Fit the selector unit onto the gearbox (A).

Tightening torque: 25 Nm (18 lbf ft)


3. Connect the gear cables.

• Press the locking sleeves backward and fit the gear cable sheaths in the bracket (D)


• Fit the gear cables for the shift arms (C).

4. Fit the bleed hose (B).

5. Plug in the reversing light switch connector (A).

6. Z19: Fit the engine harness' cable tie (A).


7. Adjust the gear positions in accordance with Adjusting gear cables

8. Fit Battery cover, lower section .

9. Fit the battery

10. Carry out Measures after disconnecting the battery .