Brake caliper, rear, 4WD
Brake caliper, rear, 4WD |
To remove |
1. |
Lift the rear of the car in order to remove the rear wheel at a later time.
|
2. |
Remove fuse 6 from
instrument panel electrical centre 22
.
|
3. |
Depress the brake pedal slightly using a brake pedal clamp.
|
4. |
Loosen the handbrake adjustment so that the cables can be unhooked from the brake caliper. See
Adjusting the handbrake cable
.
|
5. |
Raise the car.
|
6. |
Remove the wheel.
|
7. |
Remove the bolts for the bushings (A) and fold down the anti-roll bar (B).
|
8. |
Remove the brake hose from the hydraulic body (A).
|
9. |
Remove the handbrake cable (B) from the hydraulic body.
|
10. |
Remove the retaining spring (C) from the brake caliper.
|
11. |
Remove the protective covers (D) and remove the hydraulic body.
|
12. |
Remove the outer and inner brake pads.
|
13. |
Clean the inside of the brake caliper and check the dust covers.
|
14. |
Remove the carrier from the steering swivel member (E).
|
To fit |
1. |
Clean the contact surfaces between the steering swivel member and the brake caliper carrier.
|
2. |
Fit the brake caliper carrier to the steering swivel member. Apply
74 96 268 Thread locking adhesive
to the bolts.
Tightening torque 130 Nm +45° (96 lbf ft +45°) |
3. |
Screw in the brake piston (A) if necessary with
89 96 969 Resetting tool
(B) and
89 96 977 Adapter
(C).
|
4. |
Lubricate the pad sliding and contact surfaces with
Special paste
.
|
5. |
Fit the brake pads.
|
6. |
Fit the hydraulic body.
Tightening torque 28 Nm (21 lbf ft) |
7. |
Fit the protective covers (D).
|
8. |
Fit the retaining spring (C) to the brake caliper.
|
9. |
Fit the handbrake cable (B) to the hydraulic body.
|
10. |
Fit the brake hose (A) with new seals on the hydraulic body.
Tightening torque: 40 Nm (30 lbf ft) |
11. |
Remove the brake pedal clamp and refit fuse 6 in the instrument panel electrical centre 22.
|
12. |
Bleed the brake system
.
|
13. |
Adjust the handbrake.
|
14. |
Fold up the anti-roll bar (B) and fit the bolts for the bushings (A).
Tightening torque 30 Nm (23 lbf ft) |
15. |
Fit the wheel
.
|
16. |
Lower the car.
|
17. |
Depress the brake pedal repeatedly in order to press out the brake piston and the handbrake self adjustment.
|
18. |
Check the operation of the foot brake and handbrake.
|