SAAB WIS ONLINE

Delivery line for power steering, A20NFT/LHU

Delivery line for power steering, A20NFT/LHU

Important

Scrupulous cleanliness must always be observed during all work with hydraulic components.


Important

Always use wing covers when working in the engine bay.


To remove


1. Lift off the battery cover and disconnect the negative battery cable.

2. Remove the right-hand wheel arch liner.

3. Lower the subframe about 100 mm (4 in). See Subframe, A20NFT/LHU .

4. Position a receptacle under the car. Remove the delivery line (A) from the steering gear and plug the connection.


5. Remove the delivery line from the power steering pump (B).

6. Remove the delivery line.


To fit


1. Attach the delivery line to the power steering pump (B).

Tightening torque 27 Nm (20 lbf ft)


2. Fit the delivery line (A) to the steering gear. Use new O-rings.

Tightening torque 32 Nm (24 lbf ft)

3. Wipe clean any spilled oil from the subframe.

4. Install Subframe, A20NFT/LHU .

5. Install the right-hand wheel arch liner.

6. Connect the negative battery cable and fit the battery cover.

7. Fill with power steering fluid and bleed the power steering steering system, see Hydraulic system EHPS, filling and bleeding, A20NFT/LHU .

8. Carry out Procedures after disconnecting the battery.