Subframe bush, A19DTH/DTR, A20NFT/LHU
Subframe bush, A19DTH/DTR, A20NFT/LHU |
Note | ||
This method involves destructive disassembly. It is not possible to refit the old bush. |
To remove |
1. |
Remove the subframe, see
Subframe, A20NFT/LHU
and
Subframe, remove and install, Z19
|
2. |
Cut away the rubber from the bush.
|
3. |
Saw or cut a groove on either side. Break off the flange from the bush to make room for the support.
|
4. |
Cut away the rubber edge protruding from the underside of the bush.
|
5. |
Remove the bush using a pull rod 907 and press sleeve KM 907-14 from
89 96 779 Set of press sleeves, front assembly
and a support from
89 96 902 Subframe bush set
|
To fit |
Note | ||
Make sure the bush is pressed in straight. |
1. |
Press in the bush using sleeves from the
89 96 902 Subframe bush set
.
|
2. |
Fit the subframe, see
Subframe, A20NFT/LHU
and
Subframe, remove and install, Z19
|