Upper suspension arm, 4WD
|
|
Upper suspension arm, 4WD
|
|
2.
|
Remove the wheel sensor wiring harness (A) from the upper suspension arm.
|
|
3.
|
Remove the upper suspension arm mounting (A) from the subframe.
|
|
4.
|
Remove the upper suspension arm mounting (A) from the steering swivel member. Remove the ball joint from the steering swivel member using
87 91 287 Puller, 150 mm
.
|
|
5.
|
Remove the upper suspension arm.
|
|
1.
|
Fit the upper suspension arm into place.
|
|
2.
|
Fit the bolts for the upper suspension arm mounting to the subframe.
|
|
3.
|
Fit the upper suspension arm mounting (A) to the steering swivel member.
Tightening torque 60 Nm + 60° (44 lbf ft +60°)
|
|
4.
|
Raise the steering swivel member to normal position 374 mm (A) between the drive shaft centre and the wing edge.
|
|
5.
|
Fit the nut (A) of the suspension arm mounting to the subframe.
Tightening torque 75 Nm + 90° (55 lbf ft +90°)
|
|
6.
|
Fit the wheel sensor wiring harness (A) to the upper suspension arm.
|
