Impact sensor, side (328D, 328P), CV
|
Impact sensor, side (328D, 328P), CV
|
Warning
|
|
|
|
|
Warning
|
The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.
|
|
|
|
|
2.
|
Turn the ignition key to the LOCK position.
|
3.
|
Set the seat to its front position.
|
4.
|
Remove the inner sill trim.
|
5.
|
Fold under the carpet.
|
6.
|
Remove the protective plate.
|
7.
|
Release the screws a few turns, press the locking clip together on the rear of the side impact sensor. Press the front of the side impact sensor back and lift out the sensor.
|
8.
|
Remove the connector from the side impact sensor.
|
1.
|
Attach the connector to the side impact sensor.
|
2.
|
Position the sensor and pull the front part forwards. Tighten the screws.
Tightening torque 6 Nm (4.5 lbf ft)
|
3.
|
Refit the protective plate.
|
5.
|
Refit the inner sill trim.
|
8.
|
Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostics tool, delete any diagnostic trouble codes.
Switch off the ignition and then on again. Wait at least 1 minute with the ignition switched on.
Check whether a diagnostic trouble code is shown.
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostics instrument.
|