Upper mounting, radiator

/ 9-3 (9440) / 2012 / 8. Body / Body / Body panel / Adjustment/replacement / Upper mounting, radiator

Replacement

1.	Even out the break surface.

2.	Fit the new mounting on the flange. Important Be careful not to damage the radiator end when drilling the hole.

3.	Drill holes through the mounting and flange using a 4 mm bit.

4.	Remove the mounting from the flange. Fit the nut in the mounting.

5.	Fit the mounting to the flange with washer and bolt. Tightening torque 3.5 Nm (2.5 lbf ft)

6.	Fit the upper rubber supports to the radiator.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.