UHP / B1001 00
Read the instructions below then start the fault diagnostic procedure.
| B1001 00 |
Controle Module not Added
On-board diagnosis
Type of diagnosis:
| Diagnostics runs each time the control module is switched on. |
Enable criteria:
| Ignition ON. |
Fault criteria:
| Control module not configured. |
Diagnostic help
Control module was not added.See "Procedure after fitting the control module"
See menu "All - Add/Remove"
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
