SAAB WIS ONLINE

Cylinder Head Installation - Right Side (LAU or LBW)

Cylinder Head Installation - Right Side (LAU or LBW)


Special Tools

EN 45059 Angle Meter

For equivalent regional tools, refer to Special Tools .



1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.

Install a NEW cylinder head gasket bank 1 using the deck face locating pins for retention.


2. Align the cylinder head bank 1 with the deck face locating pins.


3. Place the cylinder head bank 1 in position on the deck face.

4. Refer to Fastener Caution .

Note
• DO NOT allow oil on the cylinder head bolt bosses.

• DO NOT reuse the old cylinder head bolts.


Install the NEW M11 cylinder head bolts (1).


4.1. Tighten the M11 cylinder head bolts a first pass in sequence to 30 Nm (22 lb ft) .

4.2. Tighten the M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the EN-45059 meter.

5. Install the NEW M8 cylinder head bolt (2).

5.1. Tighten the M8 cylinder head bolts a first pass in sequence to 15 Nm (11 lb ft) .

5.2. Tighten the M8 cylinder head bolt a second pass an additional 75 degrees using the EN 45059 meter.