Cylinder Head Installation - Right Side (LF1, LFW or LFX)
|
Cylinder Head Installation - Right Side (LF1, LFW or LFX)
|
Special Tools
EN 45059
Angle Meter
For equivalent regional tools, refer to
Special Tools
1.
|
Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
|
2.
|
Install a NEW right cylinder head gasket (1) using the deck face locating pins for retention.
|
3.
|
Align the right cylinder head (2) with the deck face locating pins.
|
4.
|
Place the right cylinder head in position on the deck face.
|
5.
|
Refer to
Fastener Caution
.
Note
|
DO NOT allow oil on the cylinder head bolt bosses.
|
Note
|
DO NOT reuse the old cylinder head bolts.
|
Install the NEW M11 cylinder head bolts (1).
|
|
5.1.
|
Tighten the M11 cylinder head bolts a first pass in sequence to
30 Nm (22 lb ft)
.
|
|
5.2.
|
Tighten the M11 cylinder head bolts a second pass in sequence an additional
150 degrees
using the
EN 45059
meter.
|
6.
|
Install the NEW M8 cylinder head bolt (2).
|
|
6.1.
|
Tighten the M8 cylinder head bolts a first pass in sequence to
15 Nm (11 lb ft).
|
|
6.2.
|
Tighten the M8 cylinder head bolt a second pass an additional
75 degrees
using the
EN 45059
meter.
|