Engine Flywheel Installation
Engine Flywheel Installation |
Special Tools
• |
EN 45059
Angle Meter
|
• |
EN 46106
Flywheel Holding Tool
|
For equivalent regional tools, refer to Special Tools
1. |
Place the engine flywheel in position on the crankshaft.
|
2. |
Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
|
3. |
Install the
EN 46106
tool .
|
4. |
Refer to
Fastener Caution
.
Install the remaining NEW engine flywheel bolts. |
4.1. |
Tighten the NEW engine flywheel bolts to
30 Nm (22 lb ft)
.
|
4.2. |
Tighten the NEW engine flywheel bolts an additional
45 degrees
using the
EN 45059
meter.
|
5. |
Remove the
EN 46106
tool .
|