Engine Front Cover Cleaning and Inspection (LAU or LBW)
|
|
Engine Front Cover Cleaning and Inspection (LAU or LBW)
|
Special Tools
EN 28410
Gasket Remover
For equivalent regional tools, refer to
Special Tools
.
|
1.
|
Remove any RTV sealant (1) from the engine front cover using
EN 28410
remover.
|
|
2.
|
Clean out debris from the bolt holes.
|
|
3.
|
Clean the engine front cover in solvent.
|
|
1.
|
Inspect the exterior of the engine front cover for the following conditions:
|
|
|
•
|
Damage to the water pump bolt hole threads (7)
|
|
|
•
|
Gouges or damage to the water pump sealing surfaces (6)
|
|
|
•
|
Damage to the crankshaft front oil seal bore (5)
|
|
|
•
|
Damage to the camshaft position actuator valve oil seal bores (1)
|
|
|
•
|
Damage to the engine front cover bolt holes (2)
|
|
|
•
|
Damage and/or corrosion to the engine coolant passage (3)
|
|
|
•
|
Dents or damage to the exterior (4)
|
|
2.
|
Inspect the interior of the engine front cover for the following conditions:
|
|
|
•
|
Gouges or damage to the engine front cover sealing surfaces to the engine block (7), oil pan (5), and/or camshaft covers (2)
|
|
|
•
|
Damage and/or corrosion to the engine coolant passage (6)
|
|
|
•
|
Damage to the crankshaft front oil seal bore
|
|
|
•
|
Gouges or damage to the O-ring sealing areas
|
|
|
•
|
Gouges or damage to the water pump seal area (3)
|
|
|
•
|
Loose or damaged deadener plates (4)
|
|
|
•
|
Damage to the engine front cover bolt holes (1)
|
|
3.
|
Repair or replace the engine front cover as necessary.
|
