Ignition Coil Replacement - Bank 2

/ 9-4x / 2011 / 2. Engine / Engine management and fuel system, V6 / Adjustment/replacement / Ignition Coil Replacement - Bank 2

Removal Procedure

1.	Remove the intake manifold. Refer to Intake Manifold Replacement .

2.	Disconnect the engine wiring harness electrical connector(s) (5) from the ignition coil(s) (4).

3.	Remove the ignition coil bolt(s).

4.	Remove the ignition coil(s).

Installation Procedure

1.	Install the ignition coil(s).

2.	Refer to Fastener Caution . Install the ignition coil bolt(s). Tighten Tighten the bolt(s) with 10 Nm (89 lb in).

3.	Connect the engine wiring harness electrical connector(s) (5) to the ignition coil(s) (4).

4.	Install the intake manifold. Refer to Intake Manifold Replacement .

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.