HVAC System Control Module Programming and Setup
|
HVAC System Control Module Programming and Setup
|
The following service procedures require either a programming or a setup event performed for a complete repair.
HVAC Control Module Replacement
|
If the HVAC control module needs to be replaced, the following procedures must be performed:
2.
|
Perform the SPS function Remote Heater and Air Conditioning Control Module Programming and follow the on-screen instructions.
|
3.
|
Perform the SPS function Remote Heater and Air Conditioning Control Module Configuration & Setup and follow the on-screen instructions.
|
4.
|
Clear DTCs after completing the programming procedure.
|
HVAC Control Module Reprogramming
|
Do not reprogram the HVAC control module unless directed by a service procedure or a service bulletin.
2.
|
Perform the SPS function Remote Heater and Air Conditioning Control Module Programming and follow the on-screen instructions.
|
3.
|
Clear DTCs after completing the programming procedure.
|
Setup for Component Replacement
|
If an actuator is replaced, the following procedure must be performed:
Recalibrate actuators for the HVAC system. Refer to
Actuator recalibration
.