Parameter
|
Expected Value
|
Description
|
Operating Conditions:
Ignition ON, Parking Brake Off
|
Base Hardware
|
Varies
|
The scan tool displays the base hardware number.
|
BCM Brake Pedal Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the body control module brake pedal as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|
Calculated System Temperature
|
Varies
|
The scan tool displays the parking brake control module temperature in degrees Celsius.
|
Calibrations
|
Varies
|
The scan tool displays the calibration number.
|
EBCM Emergency Park Brake Enable Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the electronic brake control module emergency park brake enable signal as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|
ECM Accelerator Pedal Position Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the engine control module accelerator pedal position signal as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|
ECM Clutch Pedal Position Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the engine control module clutch pedal position signal as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|
ECM Vehicle Speed Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the engine control module vehicle speed signal as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|
End Model
|
Varies
|
The scan tool displays the end model number.
|
Software part number
|
Varies
|
The scan tool displays the software number.
|
Park Brake Calibration Status
|
Passed
|
The scan tool displays Passed or Failed. This parameter displays if the park brake calibration is properly programmed into the parking brake control module.
|
Park Brake Cable Position
|
Quantity
|
The scan tool displays the current park brake position in counts. When the park brake is fully released the value will be 0 counts, released 1220 counts and applied 1275-1300 counts.
|
Park Brake Motor Command
|
Off
|
The scan tool displays On or Off. This parameter displays the status of the park brake motor.
|
Park Brake Motor Duty Cycle Command
|
Varies
|
The scan tool displays the pulse width modulated cycle as a percentage.
|
Park Brake Release Reason
|
None
|
The scan tool displays None, Ign. Cycled, Spd. Threshold, or Brake Applied. This parameter displays the reason the parking brake was released.
|
Park Brake Status
|
Released
|
The scan tool displays Applied, Released, Malfunction or Invalid. This parameter displays the current status of the parking brake.
|
Park Brake Switch
|
Inactive
|
The scan tool displays Applied, Released, Inactive, or Invalid. This parameter displays the current status of the parking brake switch.
|
TCM Current Gear Signal
|
Valid
|
The scan tool displays Valid or Invalid. This parameter displays the signal status received by the transmission control module signal for engaged gear as valid or invalid. If the signal received is invalid the parking brake control module will deactivate.
|