SAAB WIS ONLINE

Instrument Cluster Scan Tool Information

Instrument Cluster Scan Tool Information


Instrument Cluster Scan Tool Data Parameters

Parameter Expected Value Description
Operating Conditions: Ignition ON
Ambient Air Temperature 15 °C (59 °F) The scan tool displays outside temperature in °C (°F).
Battery Voltage 12-14 V The scan tool displays Volts. This is the current battery voltage signal.
Boost Pressure Sensor 0-100% The scan tool displays the engine boost pressure filtered.
Coolant Level Switch Open The scan tool displays either Open, Closed, or Not Available.
Driver Information Center Reset Switch Active/Inactive The scan tool displays Active or Inactive. This is the state of the driver information center reset switch.
Driver Information Center Switch Varies The scan tool displays Volts. This is the current driver information center switch input voltage.
Driver Information Center Switch Inactive The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information center switch.
Engine Coolant Temperature °C (°F) The scan tool displays actual engine coolant temperature filtered.
Engine Oil Pressure 103 kPa (15 PSI) to 241 kPa (35 PSI) The scan tool displays the engine oil pressure filtered.
Engine Speed RPM The scan tool displays the actual engine speed.
Fuel Level Sensor % The scan tool displays fuel level percent filtered.
Key in Ignition Status Active/Inactive The scan tool displays Active or Inactive. This is the state of the key in ignition switch.
Odometer Lock Status Active/Inactive This is the state of vehicle odometer status.
Reset Switch Active/Inactive The scan tool displays Active or Inactive. This is the state of the reset switch.
Vehicle Speed km/h (MPH) The scan tool displays the actual vehicle speed.
Washer Fluid Level Switch Open The scan tool displays either Open, Closed, or Not Available.



Instrument Cluster Scan Tool Output Controls

Output Control Description
All Indicators This function is used to command all the indicators ON or OFF.
CAN Bus Configuration Learn This function is used to Reset the source ID for low speed CAN Bus communications.
Driver Information Center Dimming This function is used to command the dimming of the driver information display to Increase or Decrease by 10%.
Driver Information Center Options This function is used to command the driver information center buttons using the scan tool.
Driver Information Center Segments This function is used to command the driver information center segments ON and OFF.
Instrument Cluster Gauge Sweep This function is used to command the gauges to sweep from minimum to maximum.
Instrument Panel Dimmer Switch This function is used to command the dimming of the instrument cluster to Increase or Decrease by 10%.
Odometer Programming This function is used to command the odometer to reset.