Auxiliary Battery Positive Cable Replacement

/ 9-4x / 2011 / 3. Electrical System / Charging and starting system / Adjustment/replacement / Auxiliary Battery Positive Cable Replacement

Removal Procedure

1.	Remove the battery fuse block cover (1).

2.	Disconnect the negative battery cable. Refer to Battery negative cable disconnection and connection

3.	Remove the auxiliary battery positive terminal nut (2) from the fuse block.

4.	Remove the nut (1) from the rear of the generator

5.	Remove the nut (2) from the starter solenoid.

6.	Remove the auxiliary battery positive cable from the vehicle.

Installation Procedure

1.	Refer to Fastener Caution . Install the auxiliary battery positive cable nut (2) to the fuse block.Tighten to 15 Nm (11 lb ft).

2.	Install the auxiliary battery positive terminal nut (1) to the back of the generator.Tighten to 15 Nm (11 lb ft).

3.	Install the auxiliary battery positive terminal nut (2) to the starter solenoid.Tighten to 15 Nm (11 lb ft).

4.	Connect the negative battery cable.Refer to Battery Negative Cable Disconnection and Connection

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.