Battery Negative Cable Replacement
| Battery Negative Cable Replacement |
| Removal Procedure |
| 1. |
Remove the battery fuse block/engine control module cover.
|
|
| 2. |
Disconnect the negative battery terminal (1).Refer to
Battery Negative Cable Disconnection and Connection
|
|
| 3. |
Remove the negative battery ground terminal (2).
|
|
| 4. |
Remove the auxiliary negative battery ground bolt (2).
|
|
| 5. |
Remove the engine block battery ground terminal (1) and bolt (2).
|
|
| 6. |
Remove the negative battery cable (3).
|
|
| Installation Procedure |
| 1. |
Refer to
Fastener Caution
.
Install the negative battery cable harness (3) to the engine block with retainer (1) and bolt (2).Tighten to 45 Nm (33 lb ft) .
|
|
| 2. |
Install the negative battery ground bolt (2) and retainer.Tighten to
22 Nm (16 lb ft)
.
|
|
| 3. |
Install the negative battery post clamp (1).Tighten to
9 Nm (80 lb in)
.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
