SAAB WIS ONLINE

Accelerator Pedal Adjuster Actuator Replacement

Accelerator Pedal Adjuster Actuator Replacement

Removal Procedure

Note

Move the adjustable pedal assembly to the full forward, front of vehicle position prior to removing components. Failure to place the adjustable pedal assembly in the full forward position may result in incorrect accelerator and brake pedal step-over height and improper adjustable pedal function.



1. Move the adjustable pedal assembly to the full forward, front of vehicle position.

2. Remove the driver knee bolster panel. Refer to Driver Knee Bolster Panel Replacement .

3. Rotate the brake pedal adjuster actuator cable collar (1) counter clockwise and disconnect the cable from the brake and accelerator pedal adjuster actuator motor.


4. Release the brake and accelerator pedal adjuster position sensor harness from the brake pedal bracket clip (1).


5. Disconnect the brake and accelerator pedal adjuster position sensor harness electrical connector (2).

6. Position the harness aside.

7. Disconnect the accelerator pedal with position sensor assembly electrical connector.


8. Remove the accelerator pedal with position sensor assembly bolt (1).

9. Remove the accelerator pedal with position sensor assembly (1).


10. Remove the accelerator pedal adjuster actuator bolts (1).


11. Remove the accelerator pedal adjuster actuator (1) from the brake pedal assembly by sliding the actuator assembly downward.



Installation Procedure


1. Install the accelerator pedal adjuster actuator (1) to the brake pedal assembly.


2. Refer to Fastener Caution .

Install the accelerator pedal adjuster actuator bolts (1) and tighten to 9 Nm (80 lb in) .


3. Install the accelerator pedal with position sensor assembly (1).


4. Install the accelerator pedal with position sensor assembly bolt (1) and tighten to 9 Nm (80 lb in) .


5. Install the brake and accelerator pedal adjuster position sensor harness to the brake pedal bracket clip (1).


6. Connect the brake and accelerator pedal adjuster position sensor harness electrical connector (2).

7. Install the brake pedal adjuster actuator cable to the accelerator pedal adjuster actuator motor.


8. Rotate the brake pedal adjuster actuator cable collar (1) clockwise to secure the cable to the brake and accelerator pedal adjuster actuator motor.

9. Connect the accelerator pedal with position sensor assembly electrical connector.

10. Calibrate the adjustable pedal system. Refer to Adjustable Pedal System Calibration .

11. Remove the driver knee bolster panel. Refer to Driver Knee Bolster Panel Replacement .