SAAB WIS ONLINE

Brake and Accelerator Pedal Adjuster Position Sensor Replacement

Brake and Accelerator Pedal Adjuster Position Sensor Replacement

Removal Procedure

Note

Move the adjustable pedal assembly to the full forward, front of vehicle position prior to removing components. Failure to place the adjustable pedal assembly in the full forward position may result in incorrect accelerator and brake pedal step-over height and improper adjustable pedal function.



1. Move the adjustable pedal assembly to the full forward, front of vehicle position.

2. Remove the driver knee bolster panel. Refer to Driver Knee Bolster Panel Replacement .

3. Release the brake and accelerator pedal adjuster position sensor harness from the brake pedal bracket clip (1).


4. Disconnect the brake and accelerator pedal adjuster position sensor harness electrical connector (2).

5. Release the locking tabs and remove the brake and accelerator pedal position sensor (1) from the bracket on the brake pedal arm.



Installation Procedure


1. Install the brake and accelerator pedal position sensor (1) to the bracket on the brake pedal arm.


2. Ensure the locking tabs on the brake and accelerator pedal position sensor bracket are firmly engaged on the sensor.

3. Calibrate the adjustable pedal system. Refer to Adjustable Pedal System Calibration .

4. Install the driver knee bolster panel. Refer to Driver Knee Bolster Panel Replacement .