Fog Lamp Aiming
Fog Lamp Aiming |
• |
Turn the hex adjustment screw clockwise in order to raise the aim.
|
• |
Turn the hex adjustment screw counter-clockwise in order to lower the aim.
|
1. |
To ensure accurate vertical front fog lamp aiming, first perform the following steps to prepare the vehicle.
|
• |
Make sure that all the components are in place on the vehicle, the tires are properly inflated, and there is not any mud or snow clinging to the vehicle.
|
• |
Stop all other operations of work on the vehicle.
|
• |
Make sure the fuel level is 1/2 full or more.
|
• |
Jounce the vehicle to settle the suspension.
|
• |
Place the vehicle on a level surface 7.6 m (25 ft) from the target screen.
|
• |
Measure the distance from the floor to the center of the fog lamp.
|
• |
Using this measurement, mark the horizontal centerline of the fog lamp on the target screen directly in front of the vehicle.
|
• |
Start the vehicle in order to level the suspension.
|
2. |
Turn the front fog lamps ON.
|
3. |
Access the fog lamp vertical adjustment screw through the radiator lower outer grille.
|
4. |
Adjust the fog lamp screw up or down until the top edge of the high intensity zone on the screen is 102 mm (4 in) below the horizontal centerline.
|
5. |
Turn OFF the front fog lamps.
|