Rear Object Sensor Housing Replacement
Rear Object Sensor Housing Replacement |
1. |
Remove the rear fascia. Refer to
Rear Bumper Fascia Replacement
.
|
2. |
Disconnect the sensor harness.
|
3. |
Remove the sensor from the sensor housing.
The sensor housing must be painted if replaced. If reinstalled, painting will not be necessary. |
4. |
Sand/grind sonic weld plastic residue from the fascia. |
5. |
Apply structural adhesive epoxy, Lord Fusorâ„¢ 127EZ or equivalent, to fascia at mating surface.
|
6. |
Using the alignment tabs, install the sensor housing to the fascia.
|
7. |
Allow adhesive to cure according to manufacturer's directions.
|
8. |
Install the sensor to the sensor housing.
|
9. |
Connect the electrical harness.
|
10. |
Install the rear fascia. Refer to
Rear Bumper Fascia Replacement
.
|