SAAB WIS ONLINE

Case Cover Assembly Disassemble

Case Cover Assembly Disassemble

ISS Removal


ISS Removal

Callout Component Name
1 A/Trans Input Speed Sensor Bolt M6 x 25
2 A/Trans Input Speed Sensor
3 A/Trans Input Speed Sensor Seal
Note

Discard the seal.


4 3-5 Reverse and 4-5-6 Clutch Fluid Seal Ring
Note

Discard the seals.




Low and Reverse Clutch Piston Removal


Low and Reverse Clutch Piston Removal

Callout Component Name
1 Low and Reverse Clutch Spring Retaining Ring
2 Low and Reverse Clutch Spring
3 Low and Reverse Clutch Piston Assembly
Note

Inspect the piston seals for damage and/or wear. The piston is reusable.




2-6 Clutch Piston Removal


2-6 Clutch Piston Removal

Callout Component Name
1 2-6 Clutch Spring Retaining Ring

Special Tools

DT-46632 Spring Compressor
For equivalent regional tools, refer to Special Tools .
2 2-6 Clutch Spring Assembly
3 2-6 Clutch Piston
Note

Inspect the piston seals for damage and/or wear. The piston is reusable.




Clean and Inspect


Clean and Inspect

Callout Component Name
Warning

After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure.


Warning

Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component.



Preliminary Procedures

1. Thoroughly clean the case cover assembly, including threads, with clean solvent.

2. Clean gasket sealing surfaces. Remove all residual gasket material.

3. Inspect all threaded holes. If necessary, repair any thread damage.


1 Gasket Sealing Surface
2 Fluid Passages
3 Piston Bores
4 Cover to Case Passages
5 A/Trans Input Speed Sensor Assembly Bore
6 Cover Casting
7 Passage Cup Plugs
8 Input Shaft Support Bolts Refer to Fastener Caution .

Procedure

Tightened bolts in sequence.

Tighten

12 Nm (106 lb in).