SAAB WIS ONLINE

Input Speed Sensor Seal Replacement

Input Speed Sensor Seal Replacement



Callout Component Name

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2. Drain the transmission, refill when repair is completed. Refer to Transmission Fluid Replacement .

3. Remove the left wheel house. Refer to Front Wheelhouse Liner Replacement .


1 Input Speed Sensor Bolt M6 x 25 Refer to Fastener Caution .
Note

Apply threadlocker to the input speed sensor bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended threadlock material.


Tighten

9 N m (80 lb in)
2 Input Speed Sensor (ISS)
Note

Pull the ISS out of the case cover just far enough to gain access to the ISS seal.


3 Input Speed Sensor Seal
Note
Remove the ISS seal by pulling it over the end of the ISS base.

Install the new ISS seal by gently stretching it over the ISS base. Overstretching the seal will cause it to not seal properly. The seal is coated with a dry lubricant. If the coating is missing, lubricate the seal with automatic transmission fluid prior to installation.