SAAB WIS ONLINE

Transmission Fluid Cooler Pipe Connector Replacement - Radiator

Transmission Fluid Cooler Pipe Connector Replacement - Radiator

Removal Procedure


1. Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716) Cooling System Draining and Filling (Static Fill LAU) Cooling System Draining and Filling (Static Fill LF1) .

2. Remove the transaxle oil cooler hoses from the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .

3.
Note

Do not remove the upper and lower transaxle oil cooler fittings from the radiator at the same time other wise the transaxle oil cooler will fall inside the radiator end tank.


Remove the oil cooler fitting from the radiator.



Installation Procedure


1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.

2. Refer to Fastener Caution .

Note

The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.


Install the oil cooler fitting to the radiator and tighten to 38 Nm (28 lb ft) .


3. Install the transaxle oil cooler hoses to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .

4. Fill the cooling system. Refer to Cooling System Draining and Filling (GE 47716) Cooling System Draining and Filling (Static Fill LAU) Cooling System Draining and Filling (Static Fill LF1) .

5. Adjust the transmission fluid level.

6. Inspect for fluid leaks.