SAAB WIS ONLINE

Power Steering System Bleeding

Power Steering System Bleeding



1.
Note
Use clean, new power steering fluid only. Refer to Adhesives, Fluids, Lubricants, and Sealers .

Hoses touching the frame, body or engine may cause system noise. Ensure the hoses do not touch any other part of the vehicle.

Loose connections may not leak, but could allow air into the steering system. Ensure all hose connections are tight.

Maintain the power steering fluid level throughout the bleeding procedure.


Fill the power steering fluid reservoir with fluid to the minimum system level, the FULL COLD level, or the middle of the hash mark on the cap stick fluid level indicator, as applicable.

2. Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle .

3. With the key in the ON position and with the engine OFF, turn the steering wheel from stop to stop 12 times.

If the vehicle is equipped with longer length power steering hoses, turn the steering wheel from stop to stop 15 to 20 times.

4. Verify the power steering fluid level. Refer to Checking and Adding Power Steering Fluid .

5. Start the engine. Rotate the steering wheel from left to right. Inspect the power steering system for signs of cavitation or fluid aeration, like pump noise or whining.

6. Check fluid level. Repeat the bleed procedure, if necessary.

7. Lower the vehicle.