SAAB WIS ONLINE

Steering Linkage Outer Tie Rod Replacement

Steering Linkage Outer Tie Rod Replacement



Callout Component Name

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .


1 Steering Linkage Outer Tie Rod Nut Refer to Fastener Caution .

Tighten


1. 25 Nm (18 lb ft)

2. 90 degrees


2 Steering Linkage Inner Tie Rod Nut

Procedure

1. Use paint in order to place match marks on the steering linkage inner tie rod nut and on the steering linkage inner tie rod.

2. During installation, align the match marks.

3. Do not tighten the nut during installation. Tighten the nut after adjusting the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .


3 Steering Linkage Outer Tie Rod
Warning

Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.



Procedure

1. Use the CH-24319-B puller in order to separate the steering linkage outer tie rod from the steering knuckle.

2. Inspect the steering linkage inner tie rod for bent or damaged threads.

3. Clean the tapered surface of the steering knuckle.

4. After the installation is complete, measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .


Special Tools

CH-24319-B Steering Linkage and Tie Rod Puller
For equivalent regional tools, refer to Special Tools .