Poor Return of Steering Wheel
|
Poor Return of Steering Wheel
|
Step
|
Action
|
Yes
|
No
|
DEFINITION: After completing a turn, extra steering input is required for the steering wheel to return to center.
|
1
|
Did you review the Power Steering System Description and Operation and perform the necessary inspections?
|
Go to
Step 2
|
Go to
Symptoms - Power Steering System
|
2
|
Verify that poor return of the steering wheel is present.
Does the system operate normally?
|
System OK
|
Go to
Step 3
|
3
|
2.
|
Lubricate the tie rod ends and ball joints, if applicable.
|
3.
|
Inspect the suspension system for worn or damaged components.
|
Did you find and correct the condition?
|
Go to
Step 12
|
Go to
Step 4
|
4
|
1.
|
Rotate the steering wheel ONE revolution in both directions.
|
2.
|
Rotate the steering wheel back to the original position.
|
Was the steering wheel abnormally difficult to rotate in either direction?
|
Go to
Step 5
|
Go to
Step 10
|
5
|
Note
|
Position the wheels straight ahead. Do NOT rotate the steering wheel more than one complete revolution from center.
|
1.
|
Disconnect the intermediate shaft from the steering column.
|
2.
|
Note the position of the steering wheel and rotate the steering wheel ONE revolution in both directions.
|
3.
|
Rotate the steering wheel back to the original position.
|
Was the steering wheel abnormally difficult to rotate in either direction?
|
Go to
Step 11
|
Go to
Step 6
|
6
|
Inspect the intermediate shaft for stiff or loose joints. Repair or replace as necessary.
Did you find and complete the repair?
|
Go to
Step 12
|
Go to
Step 7
|
7
|
2.
|
Disconnect both outer tie rod ends from the steering knuckles.
|
3.
|
Use your hands in order to move the tie rod end studs.
|
4.
|
If abnormally difficult to move, replace the tie rod end. If equipped with recirculating ball steering, ensure that idler and pitman arm joints are not to stiff. Repair if necessary.
|
Did you find and complete the repair?
|
Go to
Step 12
|
Go to
Step 8
|
8
|
1.
|
Use your hands to rotate the steering knuckle inboard and outboard in order to inspect for a binding strut bearings, ball joints, or axle.
|
2.
|
Repair or replace any abnormally stiff or loose components.
|
Did you find and complete the repair?
|
Go to
Step 12
|
Go to
Step 9
|
9
|
Inspect for binding in the steering gear. If a binding is present, repair or replace the steering gear.
Did you find and complete the repair?
|
Go to
Step 12
|
Go to
Step 10
|
10
|
Inspect the wheel alignment and adjust as necessary. Refer to
Wheel Alignment Measurement
.
Did you find and complete the repair?
|
Go to
Step 12
|
-
|
11
|
Inspect the steering column for a binding. If a binding is present, repair or replace the steering column as necessary.
Did you find and complete the repair?
|
Go to
Step 12
|
-
|
12
|
Operate the system in order to verify the repair.
Did you correct the condition?
|
System OK
|
-
|