Inflatable Restraint Side Impact Sensor Replacement - Rear
|
|
Inflatable Restraint Side Impact Sensor Replacement - Rear
|
|
Callout
|
Component Name
|
Warning
|
|
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
|
|
|
|
|
|
|
Warning
|
|
Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
|
|
|
|
|
|
Preliminary Procedures
|
|
1
|
Inflatable Restraint Side Impact Sensor Assembly
Refer to
Fastener Caution
.
Procedure
|
1.
|
Loosen the fasteners and slide the sensor out of the keyhole slots.
|
|
2.
|
The bolts are integral to the sensor assembly, DO NOT remove separately.
|
|
Note
|
|
The sensor is located on the inside of the rear door inner panel.
|
Tighten
10 Nm (89 lb in)
|
